|March 13, 2013, 04:41||
Propagation of errors on the Enthalpy diagram
Join Date: Nov 2012
Posts: 26Rep Power: 4
Hi, I'm going to conduct some experimental test on a steam turbine.
I have a question about the propagation of the errors on the enthalpy diagram (TS).
I measure the pressures and the temperatures whit the instrumentation but I have to gather the Enthalpies by reading them in the TS diagram.
How would be the percentage of error on the enthalpy if I had an 1% of error in both the measures of pressure and temperature?
|Thread||Thread Starter||Forum||Replies||Last Post|
|How to write k and epsilon before the abnormal end||xiuying||OpenFOAM Running, Solving & CFD||8||August 27, 2013 15:33|
|Building OpenFOAM1.7.0 from source||ata||OpenFOAM Installation||42||May 14, 2012 20:48|
|Upgraded from Karmic Koala 9.10 to Lucid Lynx10.04.3||bookie56||OpenFOAM Installation||8||August 13, 2011 04:03|
|IcoFoam parallel woes||msrinath80||OpenFOAM Running, Solving & CFD||9||July 22, 2007 02:58|
|Could anybody help me see this error and give help||liugx212||OpenFOAM Running, Solving & CFD||3||January 4, 2006 19:07|