|April 5, 2013, 04:03||
periodic boundary condition for one face of a (3D) rectangular duct domain
Join Date: Apr 2013
Posts: 5Rep Power: 3
I am new to CFD and i m simulation on the film cooling on a flat plate, and i used gambit for modelling a 3D rectangular geometry as a domain. The bottom face of the rectangular duct is the taken as the test plate.
I gave the following boundary conditions:-
1. duct inlet > Velocity inlet
2. duct outlet> pressure outlet
3. test plate > wall
4. Top side> wall( opp face of test plate)
5. right side face> symmetry
6. left side face> Periodic
After that i did export > mesh, but the file is not exporting successfully.
It is showing some errors with the periodic boundary condition, they are
warn: boundary entity periodic side shadow does not contain any valid entity and is not written.
error: periodic boundary entities are not specified on the same boundary entity.
please help... what is the error and how can I resolve it...
thanks in advance
|April 5, 2013, 07:39||
Join Date: May 2009
Posts: 129Rep Power: 7
|Thread||Thread Starter||Forum||Replies||Last Post|
|[GAMBIT] periodic boundary condition for a rectangular duct domain||Das||ANSYS Meshing & Geometry||26||June 5, 2013 07:48|
|error message with modeling a cube with a hold at the center||hsingtzu||OpenFOAM Native Meshers: blockMesh||2||March 14, 2012 10:56|
|RPM in Wind Turbine||Pankaj||CFX||9||November 23, 2009 04:05|
|fluent add additional zones for the mesh file||SSL||FLUENT||2||January 26, 2008 11:55|
|Please help with flow around car modelling!||Tudor Miron||CFX||17||March 19, 2004 19:23|