 |
 |
 |
|
|
|
[Sponsors] | ||||
July 12, 2006, 12:37
|
3D Preconditioning
|
#1 |
|
Guest
Posts: n/a
|
Dear Friends,
I am working on 3D preconditioning for Euler flows and am faced with a small problem. For flow past ONERA M6 wing, and M<=0.001, I find that the velcoity and pressure contours are corrupt, right from the first iteration. There is no such problem for M>0.001. In fact, I get a good solution at M=0.01. The preconditioner works well at high M. I make use of Weiss-Smith preconditioner and have validated it extensively in 2D. Can anyone who has worked in 3D preconditioning give some suggestions ? Regards, Ganesh |
|
|
||
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Roe implement about preconditioning | ricklee | Main CFD Forum | 7 | July 7, 2006 06:14 |
| Re: Preconditioning for moving grids | ganesh | Main CFD Forum | 0 | April 6, 2006 06:18 |
| Preconditioning in 3D | ganesh | Main CFD Forum | 0 | February 28, 2006 06:39 |
| implementing preconditioning | clifford bradford | Main CFD Forum | 0 | October 19, 2000 16:03 |
| local preconditioning | Manish Jaiman | Main CFD Forum | 3 | May 1, 2000 08:31 |
Linear Mode
