|July 23, 2013, 19:36||
remesh to solve error
Join Date: Jul 2013
Posts: 12Rep Power: 3
ERROR: Tetrahedral meshing has failed for volume outer.
This is usually caused by problems in the face meshes.
Check the skewnesses of your face meshes and make sure
the face mesh sizes are not too large in areas of
Actually, I have a truck placed in wintunnel, I could get the results. But when I add devices to it, and try to mesh it again I'm getting the above error. Any suggestions.
Last edited by pendyala; July 23, 2013 at 20:10. Reason: Error I copied from one post, so had to change few details
|Thread||Thread Starter||Forum||Replies||Last Post|
|Pressure outlet boundary condition||rolando||OpenFOAM Running, Solving & CFD||58||November 12, 2014 14:51|
|installing funkySetFields||igo||OpenFOAM||1||November 20, 2012 21:16|
|Ansys Fluent 13.0 UDF compilation problem in Window XP (32 bit)||Yogini||Fluent UDF and Scheme Programming||7||October 3, 2012 07:24|
|groovyBC||sega||OpenFOAM Running, Solving & CFD||12||February 17, 2010 10:30|
|Version 15 on Mac OS X||gschaider||OpenFOAM Installation||120||December 2, 2009 11:23|