What module should i use for rotatory geometry?

Maralady · March 31, 2013, 18:45

I will work on a Rotatory Geometry, it is a twin screw pump and i would like to know your advice about what module should i use to this analysis, should i use FLUENT, CFX or other? Please leave adv. and disv. in your comment.

M M · August 3, 2013, 06:59

If You Have found the answer, would you let me know?

Maralady · August 3, 2013, 12:16

So far I understand that I can use DEFINE_CG_MOTION, this is because I am using 2 rotating bodies that present no deformation at all

M M · August 4, 2013, 01:17

Actually I am working on the same title, may I know how have you got the geometry for your simulation?how far have you gone so far in your effort?

shuai_manlou · August 5, 2013, 02:24

In fluent, you can use MRF method or sliding mesh to solve the problem.

March 31, 2013, 18:45	What module should i use for rotatory geometry?	#1
Maralady Member Arthur Loginow Join Date: Aug 2012 Posts: 99 Rep Power: 13	I will work on a Rotatory Geometry, it is a twin screw pump and i would like to know your advice about what module should i use to this analysis, should i use FLUENT, CFX or other? Please leave adv. and disv. in your comment.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Question about Geometry vs. Meshes	EphemeralMemory	ANSYS Meshing & Geometry	2	December 8, 2016 13:02
[DesignModeler] Error while Loading a Geometry	JD944	ANSYS Meshing & Geometry	0	October 25, 2011 14:51
[ANSYS Meshing] need to convert a cell based geometry into STL or CGNS	kamran_kibria	ANSYS Meshing & Geometry	0	September 15, 2011 05:14
Reg difficulties in meshing the geometry...Urgent	arunraj	ANSYS Meshing & Geometry	0	August 26, 2011 23:25
[snappyHexMesh] SnappyHexMesh meshes inside and outside of an STL geometry	villier	OpenFOAM Meshing & Mesh Conversion	17	June 15, 2010 19:51

August 3, 2013, 06:59		#2
M M New Member Mohamad Mansouri Join Date: Aug 2013 Posts: 5 Rep Power: 12	If You Have found the answer, would you let me know?

August 3, 2013, 12:16		#3
Maralady Member Arthur Loginow Join Date: Aug 2012 Posts: 99 Rep Power: 13	So far I understand that I can use DEFINE_CG_MOTION, this is because I am using 2 rotating bodies that present no deformation at all

August 4, 2013, 01:17		#4
M M New Member Mohamad Mansouri Join Date: Aug 2013 Posts: 5 Rep Power: 12	Actually I am working on the same title, may I know how have you got the geometry for your simulation?how far have you gone so far in your effort?

August 5, 2013, 02:24		#5
shuai_manlou Member CAO Liushuai Join Date: Apr 2012 Posts: 30 Rep Power: 14	In fluent, you can use MRF method or sliding mesh to solve the problem.