|
[Sponsors] |
January 28, 2007, 07:43 |
3D k-e model
|
#1 |
Guest
Posts: n/a
|
I am trying to solve turbulent flow in a 3D rectangular channel using standard k-e model and FEM formulation. I am facing severe convergence problems. But I am using a mesh size of 100x20x20. The channel dimensions are 1mx0.05mx0.05m. I am not exactly sure if this convergence problem is due to a coarse mesh or some mistake in my program. Does anybody has experience with 3D problems involving k-e model.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
question about turbulence model selection and sensitivity | karananand | Main CFD Forum | 1 | February 26, 2010 04:41 |
Centrifugal Pump and Turbulence Model | Michiel | CFX | 12 | January 25, 2010 03:20 |
Problems bout CFD model of biomass gasification, Downdraft gasifier | wanglong | FLUENT | 2 | November 25, 2009 23:27 |
Reynolds Stress model in CFX vs Fluent | Tim | CFX | 1 | October 7, 2009 06:19 |
Grid resolution for full-scale and down scaled model | gravis | Main CFD Forum | 0 | October 2, 2009 10:27 |