|
[Sponsors] |
February 13, 2007, 06:17 |
wall function
|
#1 |
Guest
Posts: n/a
|
How can i apply wall function in ansys/flotran, for example spalding wall function. i must change mesh topology? coarser or finer? i did try it but not results change.For the same mesh, not result changed. I will appreciate it very much if you could kindly send me information about applying wall function in flotran
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wall function for velocity? | johnblund | OpenFOAM | 3 | September 6, 2022 07:22 |
Compile problem | ivanyao | OpenFOAM Running, Solving & CFD | 1 | October 12, 2012 09:31 |
channelFoam for a 3D pipe | AlmostSurelyRob | OpenFOAM | 3 | June 24, 2011 13:06 |
Need some wall function approaches! | yka8150 | Main CFD Forum | 0 | September 21, 2009 23:08 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |