|
[Sponsors] |
February 15, 2012, 15:51 |
Setting Solid Emissivity
|
#1 |
New Member
Yuri Singha
Join Date: Mar 2011
Posts: 7
Rep Power: 15 |
I'm currently using the S2S model to model a gray enclosure which has 5 different surfaces. The only problem is that ANSYS does not allow me to set the "internal emissivity" for the solid regions, only the fluid regions. I was wondering if anyone can help with this regarding, whether or not, I can set the internal emissivity for the solid regions.
Thank you, Yus310 |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cells with t below lower limit | Purushothama | Siemens | 2 | May 31, 2010 21:58 |
solid surface's emissivity | jarno brunetti | FLUENT | 2 | December 23, 2005 04:54 |
solid surface's emissivity | jarno brunetti | FLUENT | 0 | December 21, 2005 04:51 |
Warning 097- | AB | Siemens | 6 | November 15, 2004 04:41 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |