|
[Sponsors] |
March 25, 2014, 09:45 |
Floating point exception errror
|
#1 |
New Member
Chandresh
Join Date: Mar 2014
Posts: 1
Rep Power: 0 |
Dear Folks,
I am trying to run a transient analysis and facing an error. I have checked my mesh and it didn't show me any error. Mesh Details Mesh Check Domain Extents: x-coordinate: min (m) = -8.900000e-02, max (m) = 8.900000e-02 y-coordinate: min (m) = -1.177499e-01, max (m) = 1.307500e-01 z-coordinate: min (m) = -8.890000e-02, max (m) = 4.500000e-02 Volume statistics: minimum volume (m3): 1.965420e-12 maximum volume (m3): 4.860711e-10 total volume (m3): 5.556805e-05 Face area statistics: minimum face area (m2): 5.273181e-09 maximum face area (m2): 1.405422e-06 Checking mesh.................................... Done. The skewness is around 0.89. I also tried to lower the relaxation factor but that didn't help too I am using a Standard K-Omega model and Coupled as my solving method. I would be very thankful if someone could help me with this issue Thank you |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Floating point exception with pimpleDyMFoam | ebah6 | OpenFOAM Running, Solving & CFD | 9 | November 1, 2017 05:58 |
Inlet Velocity Profile BC - Floating Point exception during solution initialization | Janshi | STAR-CCM+ | 4 | March 14, 2012 10:21 |
simpleFoam Floating point exception error -help | sudhasran | OpenFOAM Running, Solving & CFD | 3 | March 12, 2012 16:23 |
Pipe flow in settlingFoam floating point exception | jochemvandenbosch | OpenFOAM Running, Solving & CFD | 4 | February 16, 2012 03:24 |
block-structured mesh for t-junction | Robert@cfd | ANSYS Meshing & Geometry | 20 | November 11, 2011 04:59 |