|March 25, 2014, 10:45||
Floating point exception errror
Join Date: Mar 2014
Posts: 1Rep Power: 0
I am trying to run a transient analysis and facing an error. I have checked my mesh and it didn't show me any error.
x-coordinate: min (m) = -8.900000e-02, max (m) = 8.900000e-02
y-coordinate: min (m) = -1.177499e-01, max (m) = 1.307500e-01
z-coordinate: min (m) = -8.890000e-02, max (m) = 4.500000e-02
minimum volume (m3): 1.965420e-12
maximum volume (m3): 4.860711e-10
total volume (m3): 5.556805e-05
Face area statistics:
minimum face area (m2): 5.273181e-09
maximum face area (m2): 1.405422e-06
The skewness is around 0.89.
I also tried to lower the relaxation factor but that didn't help too
I am using a Standard K-Omega model and Coupled as my solving method.
I would be very thankful if someone could help me with this issue
|Thread||Thread Starter||Forum||Replies||Last Post|
|Floating point exception with pimpleDyMFoam||ebah6||OpenFOAM Running, Solving & CFD||8||May 13, 2013 09:01|
|Inlet Velocity Profile BC - Floating Point exception during solution initialization||Janshi||STAR-CCM+||4||March 14, 2012 11:21|
|simpleFoam Floating point exception error -help||sudhasran||OpenFOAM Running, Solving & CFD||3||March 12, 2012 17:23|
|Pipe flow in settlingFoam floating point exception||jochemvandenbosch||OpenFOAM Running, Solving & CFD||4||February 16, 2012 04:24|
|block-structured mesh for t-junction||Robert@cfd||ANSYS Meshing & Geometry||20||November 11, 2011 05:59|