|
[Sponsors] |
April 16, 2014, 23:44 |
wall boundary condition for k-w SST model
|
#1 |
Senior Member
Joachim
Join Date: Mar 2012
Location: Paris, France
Posts: 145
Rep Power: 15 |
Hey everyone!
I read that the k-w SST model could be applied down to the wall without any specific treatment. I would like to apply the boundary conditions for k and w at the wall in my finite volume code (cell centered). Therefore, I need to compute the fluxes at the boundary. I can set k=0, but what should I do with w? I read in an article that the boundary condition should not be applied directly at the surface (that makes sense, since there is the distance to the wall in the denominator). My question: how should I handle the BC for w? Should I directly impose the value in the first cell? (instead of computing the fluxes, etc.) Thank you very much! Joachim |
|
April 17, 2014, 01:46 |
|
#2 |
Senior Member
Mehdi Baba Mehdi
Join Date: Jan 2011
Posts: 158
Rep Power: 15 |
Dear Friend;
in Menter's paper [1], you can find all of BC you need to apply for SST k-w. and about inflow condition, paper of Spalart and Rumsey [2] can be certainly useful. If you can not find them, Send me an email, I'll give to you this papers in which you can find your answer. [1] Menter, F. R., “Two-Equation Eddy-Viscosity Turbulence Models for Engineering Applications,” AIAA Journal, Vol. 32, No. 8, 1994, pp. 1598–1605. [2] Philippe R. Spalart and Christopher L. Rumsey. "Effective Inflow Conditions for Turbulence Models in Aerodynamic Calculations", AIAA Journal, Vol. 45, No. 10 (2007), pp. 2544-2553. |
|
April 17, 2014, 08:53 |
|
#3 |
Senior Member
Joachim
Join Date: Mar 2012
Location: Paris, France
Posts: 145
Rep Power: 15 |
Haha thanks! I was only looking at Menter 2003. Did not even think about looking at the original paper from 94...
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
Near wall treatment in k-omega SST | Arnoldinho | OpenFOAM Running, Solving & CFD | 38 | March 8, 2017 13:48 |
Multiphase simulation of bubble rising | Niru | CFX | 5 | November 25, 2014 13:57 |
What is the wall boundary condition in Mixture model? | Hamilton | FLUENT | 0 | March 17, 2014 22:12 |
No results for solid domain | Gary Holland | CFX | 10 | March 13, 2009 03:30 |