|May 1, 2014, 13:37||
Moving airfoil with constant speed: boundary conditions
Join Date: Aug 2011
Posts: 18Rep Power: 7
I am trying to simulate a moving airfoil with constant speed (Mach=0.755, =1.25). I have two boundary conditions:
2. Slip wall (airfoil)
For all faces I gave face velocities as:
Also satisfying GCL condition.
At the farfield, I set
where is the ratio of specific heats.
For slip wall I set velocity as the tangential velocity of the neighbor near boundary cell.
The flow is initialized with zero (u,v) everywhere. But with these boundary conditions residual is zero so there is no point to iterate. So how should be the proper boundary conditions?
|airfoil, boundary condition, mesh, moving|
|Thread||Thread Starter||Forum||Replies||Last Post|
|sliding mesh problem in CFX||Saima||CFX||45||September 22, 2015 10:53|
|Error finding variable "THERMX"||sunilpatil||CFX||8||April 26, 2013 07:00|
|Boundary Conditions for a standard Airfoil Optimisation Analysis||davemanson||OpenFOAM||0||March 15, 2013 18:28|
|question setting up airfoil Boundary Conditions||ibzyuk||FLUENT||0||April 9, 2010 07:47|
|RPM in Wind Turbine||Pankaj||CFX||9||November 23, 2009 05:05|