 |
 |
 |
|
|
|
[Sponsors] | ||||
August 27, 2010, 14:58
|
Basic Comsol CAD Problem
|
#1 |
|
New Member
Mark
Join Date: Aug 2010
Posts: 1
Rep Power: 0  |
I have gone through the tutorial and manual, but I still can't figure out how to cut out shapes. For example, if I make a tank and a pipe going into the tank, how do I cut out the section of the tank where the pipe goes in?
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Commercial meshers] Handling cyclic BC from gambit to openfoam for a cascade airfoil problem - OF 1.6 | maverick | OpenFOAM Meshing & Mesh Conversion | 2 | June 18, 2011 04:36 |
| Velocity profiles problem behind the elbow (3D problem) | kabat73 | FLUENT | 8 | May 9, 2010 04:26 |
| comsol cantilever beam problem | bhu47 | COMSOL | 0 | June 30, 2008 14:59 |
| convergence problem in comsol | anderson | COMSOL | 0 | February 24, 2008 16:54 |
| Solver Selection with COMSOL | S. Gatzka | COMSOL | 1 | January 27, 2008 16:35 |
Linear Mode
