 |
 |
 |
|
|
|
[Sponsors] | ||||
April 3, 2008, 07:38
|
How to simulate a static pressure sensor ?
|
#1 |
|
Guest
Posts: n/a
|
Hy guys,
i would like to simulate a static pressure sensor on a duct. I've put a small diameter pipe on the duct surface. I'd like to know which boundary condition i must impose on the top of the small diameter pipe. Do you think that a WALL boundary condition could be right? Thanks in advance |
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CFDesign and Static Pressure within Solids | royaltrude | Autodesk Simulation CFD | 2 | August 25, 2010 19:59 |
| How to simulate a static pressure sensor? | axel cole | Siemens | 1 | April 16, 2008 17:49 |
| Static pressure at outlet - Stupid question??? | Miry | CFX | 0 | September 16, 2007 18:14 |
| Does star cd takes reference pressure? | monica | Siemens | 1 | April 19, 2007 11:26 |
| negative static pressure | Selo melo | FLUENT | 5 | December 18, 2006 09:30 |
Linear Mode
