|
[Sponsors] |
July 7, 2015, 01:15 |
suppress the body???
|
#1 |
Member
Piyush Aras
Join Date: Jun 2015
Posts: 34
Rep Power: 10 |
Just consider I am modelling a flow in which water comes from a inlet on top an it splashes on the bottom wall of tank kept 40 mm down the inlet and then distributes in 6 symmetric outlets in the plate.
I am using a VOF model with primary phase as air and secondary phase as water. Just tell me one thing that during I make the geometry should I suppress the tank (body in which I filled my fluid domain) or continue with it. Will it make some difference. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
6dof model - floating body | flinde | FLUENT | 13 | March 6, 2021 14:32 |
suppress the body?? | piyusharas | FLUENT | 3 | July 7, 2015 02:20 |
Beginner questions - modelling lift and drag on a towed body | ABF | Main CFD Forum | 15 | October 19, 2014 23:27 |
6DOF with floating body bounce back. | paka | FLUENT | 4 | June 6, 2013 11:32 |
[Need some advise] Am I doing right?? Simulating a rotational mixer | setasena | STAR-CCM+ | 4 | March 10, 2013 10:32 |