TheUse of Continuous Fiber Module

RogueFeng · July 21, 2015, 04:07

I want to use continuous fiber model to complete a simulation of dry spinning. But when I loaded the model according to the instructions of the Continuous Fiber Module Manual, I found that the buttons inThe Fiber Injections Dialog Box are Gray and cannot be clicked。I want to know why they are Gray and cannot be clicked. I also would like to know what the geometry looks like.
thanx in advance.

chewy401 · October 28, 2015, 11:17

I need to use the continuous fiber module for my master thesis and have the same problem. Did you find any solution yet?

chewy401 · October 30, 2015, 05:18

If someone has the same problem as me: You have to initialize the solution before you are allowed to set the fiber injections.

July 21, 2015, 04:07	TheUse of Continuous Fiber Module	#1
RogueFeng New Member 冯老师 Join Date: Jul 2015 Posts: 1 Rep Power: 0	I want to use continuous fiber model to complete a simulation of dry spinning. But when I loaded the model according to the instructions of the Continuous Fiber Module Manual, I found that the buttons inThe Fiber Injections Dialog Box are Gray and cannot be clicked。I want to know why they are Gray and cannot be clicked. I also would like to know what the geometry looks like. thanx in advance. Last edited by RogueFeng; July 21, 2015 at 04:11. Reason: add

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Definition of continuous phase Reynolds number	gaurav_bhutani	Main CFD Forum	0	November 8, 2013 10:31
[OpenFOAM] Annoying issue of automatic "Rescale to Data Range " with paraFoam/paraview 3.12	keepfit	ParaView	60	September 18, 2013 03:23
Can someone PLEASE document the development version installation	bernd	OpenFOAM Installation	76	November 14, 2008 21:51
Continuous Fiber Model	sunyafeng	FLUENT	0	June 6, 2008 09:24
Lamboot trouble	r2d2	OpenFOAM Installation	4	October 17, 2005 04:27

October 28, 2015, 11:17		#2
chewy401 New Member Join Date: Oct 2015 Posts: 2 Rep Power: 0	I need to use the continuous fiber module for my master thesis and have the same problem. Did you find any solution yet?

October 30, 2015, 05:18		#3
chewy401 New Member Join Date: Oct 2015 Posts: 2 Rep Power: 0	If someone has the same problem as me: You have to initialize the solution before you are allowed to set the fiber injections.