do I need to mesh in ANSA if using Harpoon/t-grid?

September 30, 2008, 16:40

Hi, I have a question. Do I really need to go through with all the surface meshing in ANSA if I later will go on and export my model to Harpoon and do my surface & volume meshing there, or is it sufficient to "only" clean my model in ANSA?

October 13, 2008, 05:01

Hi Boris,

Harpoon does not require a surface mesh as input and there are hole fixing and wrapping features within Harpoon. If the geometry is particularly dirty and complicated it may save time to clean it up a bit in a ANSA or your CAD package but you will not have to go to the lengths usually required to generate a watertight surface mesh.

September 30, 2008, 16:40	do I need to mesh in ANSA if using Harpoon/t-grid?	#1
boris Guest Posts: n/a	Hi, I have a question. Do I really need to go through with all the surface meshing in ANSA if I later will go on and export my model to Harpoon and do my surface & volume meshing there, or is it sufficient to "only" clean my model in ANSA?

October 13, 2008, 05:01	Re: do I need to mesh in ANSA if using Harpoon/t-g	#2
Paul Guest Posts: n/a	Hi Boris, Harpoon does not require a surface mesh as input and there are hole fixing and wrapping features within Harpoon. If the geometry is particularly dirty and complicated it may save time to clean it up a bit in a ANSA or your CAD package but you will not have to go to the lengths usually required to generate a watertight surface mesh.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to set periodic boundary conditions	Ganesh	FLUENT	15	November 18, 2020 06:09
[snappyHexMesh] SnappyHexMesh for internal Flow	vishwa	OpenFOAM Meshing & Mesh Conversion	24	June 27, 2016 08:54
Mesh motion with Translation & Rotation	Doginal	CFX	2	January 12, 2014 06:21
ANSA for CFD mesh	santosh kangarlan	ANSA	23	March 20, 2013 10:39
2d irregular grid	Remy	Main CFD Forum	1	December 22, 2008 04:49