CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Main CFD Forum

programming glitch or concept error???

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Display Modes
Old   May 10, 2000, 04:42
Default programming glitch or concept error???
  #1
lost_soul
Guest
 
Posts: n/a
hi ppl.. i have trying to test my staggered grid code written in primitive variables over a simple problem which a rectangular box with an inflow on one side and the outflow on the other end.. however while solving the pressure poissons equation using the iterative method the solution doesnt coverge after some values.. its just stays the same. i have been following the algorithm as give in "introduction to theoretical and computational fluid dynamnics" by c.pozridikis(pg 618-620)..i guess there is some problem in the pressure boundary condition as if i comment the pressure codeline for 1 of the corner nodes it converges and gives me results as if there were a sink at that corner node..but i have sincerely tried to follow the algo in pozrikidis as it does take into the account the "correct" boundary conditions demonstrated by gresho and sani(1987). what could possibly be wrong???any hints on the rite algo?? ready to discuss with anyone on 1-to-1 basis./. just mail me.. thanks for all.. urs lost again.. lost_soul
  Reply With Quote

Old   May 10, 2000, 20:01
Default Re: programming glitch or concept error???
  #2
John C. Chien
Guest
 
Posts: n/a
(1). Corners are always very difficult areas to handle correctly in the first place. (2). Try to avoid geometry with corners first, and check out your code with rounded corners (with sufficient nodes on the rounded corner). (3). The best way to learn is to follow someone's working code, instead of following someone's published paper. In most cases, it is hard to reproduce the published results using your re-created code. (4). So, learn from the source code of a working code. Even with this method, from time to time, you will discover old bugs in a working code.
  Reply With Quote

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Compile problem ivanyao OpenFOAM Running, Solving & CFD 1 October 12, 2012 09:31
Accessing phi from a fvPatchField at same patch johndeas OpenFOAM 1 September 13, 2010 20:23
UDF: DEFINE_CG_MOTION for vertical jump motion of an electrode! alban Fluent UDF and Scheme Programming 2 June 8, 2010 18:54
OpenFOAM on MinGW crosscompiler hosted on Linux allenzhao OpenFOAM Installation 127 January 30, 2009 20:08
Problem with compile the setParabolicInlet ivanyao OpenFOAM Running, Solving & CFD 6 September 5, 2008 20:50


All times are GMT -4. The time now is 08:53.