|December 21, 2000, 15:42||
cfx, meshing + examples
i have just started using CFX 5.4 for modeling fluid flow through pipes and constriction such as nozzels and orifices.
i have been using Ansys5.5 before, but now we have to move to CFX.
i have cople of questions, first regarding the meshing processes,i am modeling 2d and 3d pipe flow with an orifice (flow meter), what is the best way to
get a regulare mesh, it is ok using free mesh, but how to build the model with regulare mesh in both cases 2d and 3d. secondely is there is a web site or
other means where i can find more examples than those in the manuals.
and at last how will i calculate the vorticity through the model (with either mesh), and how to calculate the Strouhal number for the flow over cylinder(2d
thank you regards mark
|Thread||Thread Starter||Forum||Replies||Last Post|
|Remeshing in CFX using workbench meshing.||adeban||CFX||18||August 25, 2013 01:02|
|Pros and Cons for CFX, CFdesign, COMSOL||Val||Main CFD Forum||3||June 10, 2011 03:20|
|Dynamic meshing in CFX: (negative volume error)||vmlxb6||CFX||22||October 18, 2010 18:45|
|PhD using CFX||Rui||CFX||9||May 28, 2007 06:59|
|2D simulation - ICEM meshing for CFX question||Ben Makhal||CFX||5||April 11, 2007 09:44|