boundary conditions for K and Epsilon

January 2, 2001, 08:08

I make modeling of the air flows in the greenhouses with the model K-epsilon and I ask you which values for the boundary conditions I must put in inlet for the turbulent kinetic energie (k) and for the dissipation of this energie (epsilon)?

January 2, 2001, 10:07

What is the Reynolds number in your case? Just to begin with, you can assume turbulent intensity around 5% at the inlet. Calculate K and epsilon based on this and compare the results with the experimental data. You may get reasonable match.

GS

January 3, 2001, 00:22

hi,

To start with as mentioned by Ghanshyam u need to know typical values of turbulent intensity in flows u are solving. then assume some value of eddy viscosity say Mu_eff=20*Mu_laminar (to be correct molecular viscosity) then calculate k as

k_inlet= (U_in*TU)**2 Tu=turbulent intensity.

U_in=sqrt(u*u+v*v+w*w) e_inlet= (Cmu*rho_inlet*(k_inlet)**2)/Mu_eff

hope this helps

abhijit

January 2, 2001, 08:08	boundary conditions for K and Epsilon	#1
Hicham Guest Posts: n/a	I make modeling of the air flows in the greenhouses with the model K-epsilon and I ask you which values for the boundary conditions I must put in inlet for the turbulent kinetic energie (k) and for the dissipation of this energie (epsilon)?

January 2, 2001, 10:07	Re: boundary conditions for K and Epsilon	#2
Ghanshyam Singh Guest Posts: n/a	What is the Reynolds number in your case? Just to begin with, you can assume turbulent intensity around 5% at the inlet. Calculate K and epsilon based on this and compare the results with the experimental data. You may get reasonable match. GS

January 3, 2001, 00:22	Re: boundary conditions for K and Epsilon	#3
Abhijit Tilak Guest Posts: n/a	hi, To start with as mentioned by Ghanshyam u need to know typical values of turbulent intensity in flows u are solving. then assume some value of eddy viscosity say Mu_eff=20Mu_laminar (to be correct molecular viscosity) then calculate k as k_inlet= (U_inTU)*2 Tu=turbulent intensity. U_in=sqrt(uu+vv+ww) e_inlet= (Cmurho_inlet(k_inlet)**2)/Mu_eff hope this helps abhijit

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
k epsilon boundary conditions for pisofoam ras solver	chamoun	OpenFOAM	4	May 10, 2011 05:30
Boundary conditions at Inlet for k and epsilon	Tanmay	FLUENT	1	January 26, 2009 10:42
Concentric tube heat exchanger (Air-Water)	Young	CFX	5	October 6, 2008 23:17
New topic on same subject - Flow around race car	Tudor Miron	CFX	15	April 2, 2004 06:18
Please help with flow around car modelling!	Tudor Miron	CFX	17	March 19, 2004 19:23