|
[Sponsors] |
on maximum Dean number(flow in a curved duct) |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 6, 2001, 20:30 |
on maximum Dean number(flow in a curved duct)
|
#1 |
Guest
Posts: n/a
|
hi there, i'm solving for the flow along a curved (180 degrees) rectangular duct. i wish to know, for such geometry, what is the maximum Dean number and the corresponding curvature ratio that has been solved (from the inlet to the duct outlet, probably the flow is not fully developed even at the outlet for large Dean number.) thanks in advance. regards, yfyap
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Fabric Duct Modeling | Dan | FLUENT | 0 | June 30, 2008 15:00 |
Total pressure increase in the diverging duct | shiv | Siemens | 3 | February 1, 2008 03:39 |
modelling fuel cell duct in fluent | rajesh kumar tippabhotla | FLUENT | 2 | October 7, 2004 12:04 |
flow simulation across a small fan | jane luo | Main CFD Forum | 15 | April 12, 2004 17:49 |
curved duct problem | Fellouah | FLUENT | 0 | December 9, 2002 09:23 |