|
[Sponsors] |
September 6, 2002, 16:16 |
Meshing
|
#1 |
Guest
Posts: n/a
|
Does anybody has some experience with the meshing tool harpoon (together with cfx5 or tascflow)
regards daniel |
|
September 8, 2002, 16:50 |
Re: Meshing
|
#2 |
Guest
Posts: n/a
|
If you have the right problems, Harpoon is a very nice tool for rapid meshing.
The following example of Anakin Skywalker`s podracer was meshed using harpoon based on a very coarse surface description. http://www.beilke-cfd.de/podracer.png The calculation was performed using starcd. So it should be no problem to use cfx or some other codes. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] Migrating from GAMBIT to ANSYS Meshing | David-CFD | ANSYS Meshing & Geometry | 1 | April 1, 2011 06:22 |
Best Meshing scheme for Cylinder | Nutrex | Main CFD Forum | 4 | July 29, 2008 12:03 |
Meshing locks workbench window. | andy2o | CFX | 0 | February 1, 2008 06:01 |
Singularity of grid?Volume meshing vs face meshing | Ken | Main CFD Forum | 0 | September 4, 2003 12:09 |
Volume Meshing & Face Meshing? singularity of grid | ken | FLUENT | 0 | September 4, 2003 12:08 |