 |
 |
 |
|
|
|
[Sponsors] | ||||
June 11, 2003, 03:27
|
blade interface for unsteady computation
|
#1 |
|
Guest
Posts: n/a
|
Hi all,
i have a question about the blade interface. Normally, the numbers of stator and rotor blades in turbomachinery are not equal. To conduct an unsteady simulation, the blade interface should be matched to each other. I've heard about some scaling methods to solve this problem. Can anyone tell me in detail or give me some references? I thank you very much in advance. wang |
|
|
||
|
June 11, 2003, 10:44
|
Re: blade interface for unsteady computation
|
#2 |
|
Guest
Posts: n/a
|
there are couple of techniques for this kind of problems. one is developed by Erdos J.I. refer to his AIAA paper. The otherone which will i think be suitable for your case is developed by Rai M. M. you can refer to AIAA journal for his paper
J- |
|
|
|
||
|
June 11, 2003, 12:02
|
Re: blade interface for unsteady computation
|
#3 |
|
Guest
Posts: n/a
|
Look for J.D. Dentons and W.N. Dawes paper in Journal of turbomachines particularly 1992.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
| RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
| Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
| blade interface for unsteady computation | wang | CFX | 1 | June 11, 2003 18:33 |
| Replace periodic by inlet-outlet pair | lego | CFX | 3 | November 5, 2002 20:09 |
Linear Mode
