 |
 |
 |
|
|
|
[Sponsors] | ||||
April 6, 2009, 06:12
|
Flow problem
|
#1 |
|
Member
TonyD
Join Date: Apr 2009
Posts: 85
Rep Power: 17  |
Hi all,
My question is more physics/design related then CFD but i should think that there are some experts present here. I am designing a pressure regulator, just a simple moving membrane on top of a cup, Now for safety i want to install a bleed hole in this cup. My question, where is this hole best positioned? At the edge or at the center of the cup? My idea is at the edge, this way the hole dimensions while auto adapt to the flow conditions? Any thoughts on this? |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| convergence problem of three phase flow | nick | CFX | 3 | April 25, 2008 09:00 |
| Need help with BC's for a internal flow problem | ravi | FLUENT | 2 | March 16, 2005 00:45 |
| CFX-Post: problem with mass flow | Markus | CFX | 5 | February 19, 2005 17:30 |
| transient compressible flow problem (urgent plz) | jehanzeb | FLUENT | 5 | August 3, 2004 08:04 |
| fluid flow fundas | ram | Main CFD Forum | 5 | June 17, 2000 21:31 |
Linear Mode
