|April 9, 2009, 21:50||
Icing on Airfoil by using Fluent
Join Date: Apr 2009
Posts: 140Rep Power: 9
I have a problem in which a heater is on leading edge of an airfoil and this airfoil is placed in Icing wind tunnel. Air is inside the tunnel at -5C. And water spray by using atomizer is also there.
I have to figure out what will be the temperature of airfoil at different places.
Could you tell me which model should i use? Currently i am using (solidification+VOF). But i am not getting solidification.
I don't have any clue please guide me.
It is very urgent.
Many Many thanks in advance.
Last edited by Saima; April 9, 2009 at 22:12.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Exporting structured mesh from ICEMCFD to Fluent?||jeevan kumar||FLUENT||1||January 23, 2012 12:21|
|Fidap to Fluent||Ravi||FLUENT||3||July 10, 2008 13:31|
|how to creat a mesh in fluent for airfoil||sanjay umarani||FLUENT||0||March 7, 2005 06:26|
|Fluent - license problem.||Marcin||FLUENT||1||March 4, 2005 12:41|
|Fluent equation error?!?||TOM||FLUENT||6||July 15, 2002 03:24|