|April 12, 2009, 15:21||
problem in meshing
Join Date: Apr 2009
Posts: 8Rep Power: 8
i have 2 cylinders: the first is the big one and it isvertical and the other is small and tangent to the first.
i splited the 2 volumes, than meshed the big one with hexa. When i am trying to mesh the small one (with tetra) a message appears:
check the skewness of your face meshes and make suree the mesh face sizes are not too large in areas of small gaps.
what should i do?
thanks for ure help
|April 13, 2009, 08:43||
Join Date: Mar 2009
Location: Washington, DC
Posts: 195Rep Power: 8
you need to change your mesh count/spacing along the edge of the cylinder..you need a larger number. your mesh is too coarse
|Thread||Thread Starter||Forum||Replies||Last Post|
|Problem meshing turb. blade tip clearance geometry||Balu||FLUENT||0||June 7, 2008 21:10|
|Meshing problem in GAMBIT||Vidya Raja||FLUENT||0||May 20, 2006 23:31|
|Problem meshing very thin pipe||B. Hemmen||FLUENT||2||May 16, 2006 08:29|
|meshing problem||danard||CFX||3||March 2, 2003 20:17|
|GAMBIT meshing problem||Gauthier Lambert||Main CFD Forum||1||August 3, 2000 09:22|