 |
 |
 |
|
|
|
[Sponsors] | ||||
October 5, 2003, 17:05
|
overpridiction of reattachment point
|
#1 |
|
Guest
Posts: n/a
|
Dear All, I solved backward facing step of kim et al geometry.1:3 step hight to whole diameter and 28*step hight whole length and 4*step hight inlet of step using k-eps (wall function) by a collocated simplec code. the reattachment point is around 9.4 .i don't know the reason of this overestimation instead of underpridiction.i prescribed k & eps at inlet but used uniform velocity inlet. at Re=69610.
Looking forward to hearing from you |
|
|
||
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| block-structured mesh for t-junction | Robert@cfd | ANSYS Meshing & Geometry | 20 | November 11, 2011 04:59 |
| overpridiction of reattachment point | A.M.Memarzadegan | Main CFD Forum | 3 | June 7, 2010 02:27 |
| Gmsh and samplesurface | touf | Open Source Meshers: Gmsh, Netgen, CGNS, ... | 2 | December 10, 2007 02:27 |
| compute the reattachment point | Ralf Schmidt | Main CFD Forum | 1 | April 6, 2006 16:09 |
| CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |
Linear Mode
