 |
 |
 |
|
|
|
[Sponsors] | ||||
September 13, 2009, 11:01
|
volume mesh creation help!!!
|
#1 |
|
Senior Member
ATM
Join Date: May 2009
Location: United States
Posts: 104
Rep Power: 16  |
i`m very new to CFD......i am trying to model the intake manifold of an IC engine in 3D, as i want to have the complete flow visualization with the pressure and velocity contours.... the geometry of the manifold is like that of a long pipe followed by a simple pipe elbow. i understand that i have to create volume mesh to do this.. i`m using gambit 2.2.30 and fluent 6.3.26 as solver. are there any tips on how to generate accurate volume mesh? what schemes and the grid density shud i use.. what abt the pipe walls. ...how shud it be meshed?
pls guide me.. regards\ atm |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 06:20 |
| Volume Mesh - Skewness? | David Banks | FLUENT | 11 | February 19, 2011 04:20 |
| [blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 14:11 |
| InterDyMfoam gives strange gamme if cell volume changes due to mesh motion | daniels | OpenFOAM Running, Solving & CFD | 8 | April 7, 2009 09:31 |
| On the damBreak4phaseFine cases | paean | OpenFOAM Running, Solving & CFD | 0 | November 14, 2008 21:14 |
Linear Mode
