Compressible flow model
Hi,
I would like to simulate the duct(internal flow) with inlet mach number 2. What type of boundary conditions at inlet i need to give? It is givng the warning that velocity boundary conditions should not give at inlet for compressible flow. Please give a solutions for this problem. Thanks Reddy. |
Compressible Flow
Not sure what code you are using but you likely need to apply a mass flow rate, something that will remain constant throughout the model, velocity is too vague for compressible flows.
I would have thought you would need some sort of temperature too? |
All times are GMT -4. The time now is 01:55. |