|November 13, 2009, 15:28||
FloWorks (Flow Express) Volume Goal Setting
Join Date: Nov 2009
Location: College Station
Posts: 3Rep Power: 8
First off, a little background of my situation. I am an undergrad at Texas A&M researching thermal behavior of a particular floor in a building. I have modeled the entire floor, complete with separate rooms (sealed by lids) and doors to outside conditions (also sealed by lids). The lids are suppressed as needed for simulations. There are small heat sources placed in the center of each room. I am investigating the transient thermal behavior of the floor, specifically certain rooms. I need to know when the average temperature of a certain room reaches a certain point. Take a look at the screen shot below.
The circled room is the room of interest right now, but the average temperature of each room as time progresses is desired. Boundary conditions are set on the lids highlighted in red that cause air to flow through the model as heat is supplied to the model by the small blocks in the rooms.
My current method of evaluating "average" temperature of a room involves placing random point goals, like the green dot shown, around the room and determining the time it takes for the average of these points to reach a particular temperature. I know this is not ideal, and am working on a grid system of point goals. I would really like to avoid this if possible.
SO, my question is can I set Volume Goals for each room, so I can get the true average temperature of each room?
I have tried and can only get the average entire volume of fluid in the model. I know that you can assign different volume goals to different bodies of a "multi-body part" or different parts of an assembly. I have tried some simple models to test this, but have not been able to constrict the volume of a volume goal to room.
Is there a way to manually define the volume for a volume goal? Or is there a way to "trick" FloWorks into thinking the room is an individual "body"?
I would like to not have to remodel the whole thing, but it may be possible if necessary.
Thanks and Gig 'em,
|floworks, goal, volume|
|Thread||Thread Starter||Forum||Replies||Last Post|
|On the damBreak4phaseFine cases||paean||OpenFOAM Running, Solving & CFD||0||November 14, 2008 22:14|
|Warning 097-||AB||CD-adapco||6||November 15, 2004 05:41|
|How to get volume flow rate of a section?||Nyquist||CD-adapco||1||September 14, 2003 00:27|
|fluid flow fundas||ram||Main CFD Forum||5||June 17, 2000 21:31|
|Flow visualization vs. Calculated flow patterns||Francisco Saldarriaga||Main CFD Forum||1||August 2, 1999 23:18|