 |
 |
 |
|
|
|
[Sponsors] | ||||
November 25, 2009, 05:39
|
Torque option
|
#1 |
|
New Member
Senthil
Join Date: Nov 2009
Posts: 1
Rep Power: 0  |
Hi,
I need to calculate the torque value using CFDesign in the ball valve. Let i explain to you in detailed manner, In ball valve it should not allow the fluid to pass through the other side when the ball shaft in the valve is in closed condition.From close to open of the ball stem how much torque needs to apply on the shaft to rotate the ball that has to be calculate through the CFdesign software. The inlet pressure is 90 psig and flow rate is 17.2 gpm. Regards, Senthil. |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
| mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 05:21 |
| Simulation of a single bubble with a VOF-method | Suzzn | CFX | 21 | January 29, 2018 00:58 |
| RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
| Two-Phase Buoyant Flow Issue | Miguel Baritto | CFX | 4 | August 31, 2006 12:02 |
Linear Mode
