|
[Sponsors] |
August 18, 2014, 03:26 |
Temperature problem
|
#1 |
New Member
Soheil
Join Date: Jul 2014
Posts: 5
Rep Power: 11 |
Hi..
I'm simulating a jet flow(ideal gas) and it's temperature is constant(108 F).. and because of its compressibility i used a mass flow inlet B.C , but when i initialize the temperature falls as i increase the velocity...is it ok? or should i use velocity inlet? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
temperature gradient problem in udf | Souviktor | Fluent UDF and Scheme Programming | 6 | March 10, 2019 05:48 |
Problem with Turbulent Heat Flux Temperature boundary condition | Manuel CFD | OpenFOAM Running, Solving & CFD | 11 | March 17, 2016 15:12 |
transient case velocity and temperature problem | amr mobarez | Main CFD Forum | 0 | April 28, 2014 19:00 |
Problem of negative temperature | hnemati | Main CFD Forum | 0 | April 1, 2014 05:25 |
problem in defining the temperature dependent viscosity!!! | adambarfi | OpenFOAM Programming & Development | 0 | March 5, 2013 06:25 |