|January 12, 2010, 10:18||
VOF-tubulent-flow with time varying boundaries.
Join Date: Aug 2009
Location: Wiesbaden, Germany
Posts: 241Rep Power: 10
Currently, I am simulating a spring which is turned off after a couple of seconds. I am using a VOF with an k-e-model. The simulation runs fine until 0.615s is reached, which is the the turn off time, then the simulation breaks down with in error in the k.
Basically, it is clean when I turn off the velocity at the inlet so the k value.
What have I to consider by turning the velocity of a turbulent two-phase simulation slowly to 0.
|Thread||Thread Starter||Forum||Replies||Last Post|
|autosave at flow time with adaptive time stepping||Ybes||FLUENT||0||November 3, 2007 13:32|
|Modeling in micron scale using icoFoam||m9819348||OpenFOAM Running, Solving & CFD||7||October 27, 2007 00:36|
|patch volume fraction in VOF at every time step...||Marco||FLUENT||2||October 9, 2007 05:05|
|Transient simulation not converging||skabilan||OpenFOAM Running, Solving & CFD||12||September 17, 2007 17:48|
|Time Varying BC||A.S.||CD-adapco||1||January 31, 2005 07:37|