|
[Sponsors] |
February 3, 2010, 08:37 |
help on the placement of the first node
|
#1 |
New Member
Jin Chen
Join Date: Mar 2009
Location: sweden
Posts: 27
Rep Power: 17 |
Hi all,
I make a fine mesh on all the walls and use the enhanced wall treatment for my simulation. But in fluent manual of the enhanced wall treatment, it saies typically place the first near wall node at y plus around 1. what if my y plus are 0.5 or 0.7 which are smaller than 1, could anybody tell me if such finer mesh will cause prolbem for my simulation? Thanks! |
|
February 3, 2010, 10:13 |
|
#2 |
Senior Member
Join Date: Nov 2009
Posts: 411
Rep Power: 19 |
No, it will do fine, keep your y+ under 1.
Do |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Export node number and coordinates | kezman | CFX | 2 | November 7, 2015 15:45 |
Accessing node values using a UDF | Nico | FLUENT | 2 | December 20, 2007 02:50 |
License server not visible from master node | Charles | FLUENT | 0 | October 30, 2007 17:48 |
how can i list node temperatur by node location | Ali Doustdar | FLUENT | 2 | July 12, 2007 23:48 |
Full Fluent license required for the master node? | Paul | FLUENT | 1 | September 1, 2006 04:26 |