 |
 |
 |
|
|
|
[Sponsors] | ||||
April 9, 2004, 04:18
|
thin surface
|
#1 |
|
Guest
Posts: n/a
|
I need to model a sail as part of my dissertation, and have been told that with v5.6 it is possible to make a thin surface/membrane. Ive spent hours trying to work out how this is done, but to no avail....can anyone help me out? It only needs to be 2-D as I am only looking at a small section, but it does need to be attached to a cylinder(the mast!)
Thanks a lot |
|
|
||
|
April 14, 2004, 16:09
|
Re: thin surface
|
#2 |
|
Guest
Posts: n/a
|
v5.6... sounds like CFX? Try posting in the CFX forumn.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Problems with coedge curves and surfaces | tommymoose | ANSYS Meshing & Geometry | 6 | December 1, 2020 11:12 |
| [Gmsh] Error : Self intersecting surface mesh, computing intersections & Error : Impossible | velan | OpenFOAM Meshing & Mesh Conversion | 3 | October 22, 2015 11:05 |
| [Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 02:09 |
| CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |
| free convection heat transfer from a heated horizontal surface through a liquid to a thin cooled fin | Kaushik | FLUENT | 1 | May 8, 2000 06:47 |
Linear Mode
