 |
 |
 |
|
|
|
[Sponsors] | ||||
April 14, 2010, 22:26
|
Mesh Independence Question
|
#1 |
|
New Member
MT
Join Date: Mar 2010
Location: USA
Posts: 20
Rep Power: 5  |
I am currently using COMSOL Muliphysics to solve some fluid-thermal problems and am currently doing a mesh independence study. Because of the limitations of my computer i can only perform the calculations to a certain point before I eat up all my ram. I heard about a technique a while back when I could project the error further. Is there a way to do this and are there any good references?
Thanks MT |
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ICEM 2D tetra mesh question | kawamatt2 | ANSYS Meshing & Geometry | 17 | December 1, 2010 13:07 |
| [ICEM] Hexa mesh, curve mesh setup, bunching law | Anorky | ANSYS Meshing & Geometry | 3 | December 18, 2009 10:27 |
| 2d irregular grid | Remy | Main CFD Forum | 1 | December 22, 2008 04:49 |
| Mesh independence study and Wall Y+ | sam | Main CFD Forum | 3 | September 15, 2006 08:17 |
| How to control Minximum mesh space? | hung | FLUENT | 7 | April 18, 2005 09:38 |
Linear Mode
