|September 29, 2010, 19:16||
Rescaling Turb. Boundary Layer (External flow)
Join Date: Sep 2010
Posts: 1Rep Power: 0
Has anyone had any sucess with rescaling a turbulent boundary layer?
I have implemented a recycling boundary condition for generating turbulent inlet conditions, however because the flow is external (over a flat plate) I need to rescale the boundary layer at the inlet. I am also trying to match some boundary layer parameters and the novel approach of a simple entrance length would work, however the extra element count that goes with it is undesired. I have read a few papers on this technique however it is still over my head somewhat.
If anyone has done this and can provide a better understanding that would be greatly appreciated.
|Thread||Thread Starter||Forum||Replies||Last Post|
|CGNS Compiling||Diego||Main CFD Forum||17||December 21, 2014 02:40|
|Wind turbine simulation||Saturn||CFX||34||October 16, 2014 05:27|
|To thin boundary layer?||Luk||CFX||3||February 27, 2009 04:22|
|Convective Heat Transfer - Heat Exchanger||Mark||CFX||6||November 15, 2004 16:55|
|Boundary Layer Flow Paradox||Wen Long||Main CFD Forum||3||September 24, 2002 08:47|