how to know dimensions of geometry??...plz help

siddharameshwara · October 13, 2010, 08:21

Hi to every one,

I am new to openfoam.I imported a meshed geometry file to openfoam.i don't know the dimensions of the geometry.Is it possible to know the geometry dimensions in paraview or any other means.Could you please suggest me some method to find it????

Thank you

nimasam · October 17, 2010, 02:28

yep its possible

in paraview look at
object inspector ->information -> Bounds

siddharameshwara · October 18, 2010, 04:53

hi

Thanks for reply.i have looked at it.I am getting only the x y and z range values.But my figure is not rectangle or a square.It'S similar to injector model.So i have get dimesnsions of each side.So do you know the how go get it?

Thanks

October 13, 2010, 08:21	how to know dimensions of geometry??...plz help	#1
siddharameshwara Member Join Date: Sep 2010 Posts: 36 Rep Power: 4	Hi to every one, I am new to openfoam.I imported a meshed geometry file to openfoam.i don't know the dimensions of the geometry.Is it possible to know the geometry dimensions in paraview or any other means.Could you please suggest me some method to find it???? Thank you

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] O-grid around wing geometry	Anorky	ANSYS Meshing & Geometry	12	August 17, 2011 21:28
Problem meshing an imported geometry	Alicia	Open Source Meshers: Gmsh, Netgen, CGNS, ...	0	March 30, 2010 04:53
Simulation of Flow through Complex 3D Geometry	EmersonKB	CFX	5	July 2, 2009 08:17
vitual _ real	deneb	FLUENT	3	January 22, 2007 04:31
Fluent: changing dimensions of a geometry genetaed	Madhukar Rapaka	FLUENT	3	October 12, 2005 11:40

October 17, 2010, 02:28		#2
nimasam Senior Member Nima Sam Join Date: Sep 2009 Location: Tehran, Iran Posts: 689 Blog Entries: 1 Rep Power: 10	yep its possible in paraview look at object inspector ->information -> Bounds

October 18, 2010, 04:53		#3
siddharameshwara Member Join Date: Sep 2010 Posts: 36 Rep Power: 4	hi Thanks for reply.i have looked at it.I am getting only the x y and z range values.But my figure is not rectangle or a square.It'S similar to injector model.So i have get dimesnsions of each side.So do you know the how go get it? Thanks