|December 1, 2010, 21:08||
Boundary Layer development!! Please comment.
Join Date: Oct 2010
Posts: 25Rep Power: 7
Please comment on the following velocity vector snap from FLUENT whether my flow is developed or not. I used a K-E model for the initial convergence.
My apologies for any stupid mistakes. I'm a newbie.
Velocity magnitude: 2.5 m/s
Turbulence Intensity: 10% (randomly taken)
(can we use I= 0.16x(RE)^(-1/8) to calculate Turbulence Intensity?? )
Hydraulic Dia: 0.06m (a bit confused about the HD)
Initialized the solution with Inlet BC.
Also please comment when it is necessary to refine the mesh.
|Thread||Thread Starter||Forum||Replies||Last Post|
|dsmcInitialise - dsmcFoam||archymedes||OpenFOAM Pre-Processing||93||February 11, 2014 02:22|
|Adapt mesh without modifying boundary layer cells?||Freeman||FLUENT||0||February 22, 2009 15:11|
|3D Boundary Layer||Mario||FLUENT||0||February 17, 2009 04:40|
|New topic on same subject - Flow around race car||Tudor Miron||CFX||15||April 2, 2004 06:18|
|Please help with flow around car modelling!||Tudor Miron||CFX||17||March 19, 2004 20:23|