Home > Forums > General Forums > Main CFD Forum

Centrifugal pump simulation

Updated Threads

Reply

Search this Thread

February 15, 2011, 01:01	Centrifugal pump simulation	#1
yvonne New Member @p N Join Date: Jan 2010 Location: United States Posts: 27 Rep Power: 16	Hi! Im simulating 2D geometry of a centrifugal pump and Ive specified pressure inlet(1.02 atma.) and pressure outlet(3.79 atma.) as boundary conditions. But the simulation doesn't converge and I'm getting very high mass flow rates in the report----> flux panel. The expected values is 1.833 kg/s and the obtained value is 207 kg/s. Ive looked into the FLUENT manual but I cant pinpoint the reason. Im using sliding mesh with coinciding interfaces separating the moving domain with the bulk. Any comments?

Reply

Tags

centrifugal pump, fluent, high mass flowrates, pressure boundaries

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Assistance in Vacuum pump simulation	enr_venkat	CFX	5	November 20, 2012 11:50
Rotary vane pump simulation	usker	Siemens	1	February 14, 2007 03:52
pressure measure in centrifugal pump vanes	Patricio Torrejon	FLUENT	1	December 16, 2005 17:10
centrifugal pump	novice	Siemens	2	October 11, 2004 04:29
Torque calculation in centrifugal pump	novice	Siemens	0	August 11, 2004 05:47

All times are GMT -4. The time now is 08:16.