|April 8, 2011, 02:56||
Join Date: Mar 2011
Posts: 6Rep Power: 7
I have generated the following grid using O-Type mapping can any one let me know how to improve this grid further since i have to use it to carry out some calculations.As in numerical techniques we have results either 100% correct else 0% Correct.
|April 9, 2011, 17:01||
Join Date: Mar 2009
Location: Fort Worth, Texas, USA
Posts: 240Rep Power: 10
I'm going to assume that you're computing something like a subsonic airflow over the two cylinders. Because if you're doing an FEA simulation of a plate with two holes in it this grid might be OK.
The basic issue here is one of mesh resolution and the fact that there isn't enough. To better resolve the flow around the circles you need to cells down near the surface. And you need more points, a lot more points, overall.
There might also be an issue with mesh resolution between the cylinders, but it's secondary relative to the issues cited above.
I hope you find this helpful.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Mapping results from CFD grid to structural grid of a free-form surface||mbecker||OpenFOAM Running, Solving & CFD||1||October 18, 2013 10:16|
|MapFields to New Grid For Extreme Grid Deformations due to Body Motion||albcem||OpenFOAM||0||May 5, 2009 14:17|
|GRID TO GRID INTERPOLATION in FLUENT||calogero||FLUENT||3||June 4, 2003 08:32|
|Combustion Convergence problems||Art Stretton||Phoenics||5||April 2, 2002 05:59|
|Troubles modelling flow through a grid||Hans Klaufus||CFX||1||June 28, 2000 16:43|