Hello Everybody, I have a doubt in KIVA. I have defined ncaspec value to be 45 and gave the cafin value as -57.0 degrees. When I run the code the max output I am getting is for 33 timesteps and simulation stops at crank angle of -101.0. The nclast value is 9999 and when I try to increase this value it takes onle the first four digits. So how can I simulate the code for more time steps. Thanks in advance

hi sridhar

u can simulate for more times steps(cycles).....by increasing nclast. in itape5 give it as

nclast99999

i mean don't leave any blankspace between nclast and the cycle value. hope it will work ....all the best

hi sridhar

what is the preprocessor code your using for grid generation ..... k3prep/ICEM CFD hexa or any other software.

I use K3prep as the preprocessor code in KIVA

Hi my name is selami I am student I must find Kýva program can you send program cd or trial versiyon.