|
[Sponsors] |
April 7, 2005, 22:56 |
KIVA timesteps
|
#1 |
Guest
Posts: n/a
|
Hello Everybody, I have a doubt in KIVA. I have defined ncaspec value to be 45 and gave the cafin value as -57.0 degrees. When I run the code the max output I am getting is for 33 timesteps and simulation stops at crank angle of -101.0. The nclast value is 9999 and when I try to increase this value it takes onle the first four digits. So how can I simulate the code for more time steps. Thanks in advance
|
|
April 10, 2005, 12:55 |
Re: KIVA timesteps
|
#2 |
Guest
Posts: n/a
|
hi sridhar
u can simulate for more times steps(cycles).....by increasing nclast. in itape5 give it as nclast99999 i mean don't leave any blankspace between nclast and the cycle value. hope it will work ....all the best |
|
April 10, 2005, 13:11 |
Re: KIVA timesteps
|
#3 |
Guest
Posts: n/a
|
hi sridhar
what is the preprocessor code your using for grid generation ..... k3prep/ICEM CFD hexa or any other software. |
|
April 10, 2005, 21:09 |
Re: KIVA timesteps
|
#4 |
Guest
Posts: n/a
|
I use K3prep as the preprocessor code in KIVA
|
|
May 8, 2005, 08:25 |
Re: KIVA
|
#5 |
Guest
Posts: n/a
|
Hi my name is selami I am student I must find Kýva program can you send program cd or trial versiyon.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Correction of KIVA ITAPE | hama | Main CFD Forum | 1 | December 2, 2011 13:47 |
Adaptive Timesteps | swiss_zhang | CFX | 8 | August 30, 2011 06:51 |
mesh converter in KIVA 4 | DaIN | Main CFD Forum | 0 | June 7, 2010 12:54 |
PDF - conserved scalar approach in KIVA | vega | Main CFD Forum | 0 | July 5, 2005 02:49 |
KIVA Timesteps | Sasidhar | Main CFD Forum | 4 | April 7, 2005 19:03 |