Home > Forums > General Forums > Main CFD Forum

Boundary Conditions

Mark Forums Read

Reply

Search this Thread

July 26, 2011, 07:38	Boundary Conditions	#1
atturh New Member blaze Join Date: Mar 2009 Posts: 11 Rep Power: 17	I have confusion on the BC's to be used for the below cases when I have fluid flowing through the pipe. 1. when the gas is superheat at 80C. 2.when it is two phase at 60C and 3. when it is subcooled at 50C. Im using Fluent, what kind of BC do I use. I believe using wall temps with the above gas temp will be incorrect. Appreciate your help. Thanks.

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Impinging Jet Boundary Conditions	Anindya	Main CFD Forum	25	February 27, 2016 12:58
symmetry boundary conditions in cfx	lost.identity	CFX	41	May 22, 2013 07:21
OpenFOAM Variable Velocity Boundary Conditions	NickolasPl	OpenFOAM Programming & Development	2	May 19, 2011 05:37
[Netgen] boundary conditions and mesh exporting	vaina74	OpenFOAM Meshing & Mesh Conversion	2	May 27, 2010 09:38
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues	michele	OpenFOAM Meshing & Mesh Conversion	2	July 15, 2005 04:15

All times are GMT -4. The time now is 09:56.