|
[Sponsors] |
Validation of pressure/tempature with measured pre |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 17, 2005, 05:24 |
Validation of pressure/tempature with measured pre
|
#1 |
Guest
Posts: n/a
|
I am doing the CFD work for exhaust receiver(similar to exhaust manifold) of 2-stroke large engine and I have to validate the calculated pressure/temperature at several monitoring locations with measured pressure/temperature from sensor.
The validation includes both cycle average value of pressure/temperature and pressure trace. Due to the inconsistency between CFD and measurement method, I am thinking there should be a kind of special treatment to compare them. Therefore, I'd like to get some guide for validation of pressure/temperature. For example, use of mass weighted averaged pressure/temperature instead of direct comparison of calculated pressure/temperature. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Validation test for 2d euler equations in subsonic regime with canonical squares | panou | Main CFD Forum | 2 | August 24, 2011 15:21 |
Comparing measured values with LES results | N. A. | OpenFOAM | 3 | June 27, 2011 07:05 |
Validation of Star CCM+ | iand | Siemens | 2 | December 8, 2010 06:59 |
measured pressure in the discharge pipe jumps | Jan | Main CFD Forum | 1 | October 30, 2006 07:54 |
Urgent: RAE 2822 validation | NID | Main CFD Forum | 0 | September 3, 2004 10:34 |