running analysis in STAR-CD 4.16 (why an old file is being run?)

huilian08 · September 2, 2011, 18:51

Hi,

We recently updated our STAR-CD to version 4.16, and since then I run into a bunch of problems, mainly because I do not use STAR-CD very often in the first place.

When I tried to run an analysis actively (it calles the subroutine posdat.f), but I found out it was running on an old file, not the one I just read and up-loaded in prostar. Why is this happening? I also did not see the files .prob, not sure if it is related to this issue or not.

Can anyone here provide any advice on this?

Thanks
Huilian

huilian08 · September 2, 2011, 19:04

here are the command I used to up_load the mesh file from Star-ccm+ to pro-star:

rccm,name.ccm,Restart_1
load,name.ccm,Restart_1

I can output fluid velocity data from all mesh cells fine, but somehow even after I save this into star.mdl, but the pro-star does not run the casename star? Instead, it ran a totally different old file.

Just more comments on the previous post to clarify the problem.

Thanks
Huilian

September 2, 2011, 18:51	running analysis in STAR-CD 4.16 (why an old file is being run?)	#1
huilian08 New Member huilian Join Date: Sep 2011 Posts: 2 Rep Power: 0	Hi, We recently updated our STAR-CD to version 4.16, and since then I run into a bunch of problems, mainly because I do not use STAR-CD very often in the first place. When I tried to run an analysis actively (it calles the subroutine posdat.f), but I found out it was running on an old file, not the one I just read and up-loaded in prostar. Why is this happening? I also did not see the files .prob, not sure if it is related to this issue or not. Can anyone here provide any advice on this? Thanks Huilian

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[swak4Foam] swak4foam building problem	GGerber	OpenFOAM Community Contributions	54	April 24, 2015 16:02
channelFoam for a 3D pipe	AlmostSurelyRob	OpenFOAM	3	June 24, 2011 13:06
paraview installation woes	vex	OpenFOAM Installation	15	January 30, 2011 07:11
Problem installing on Ubuntu 9.10 -> 'Cannot open : No such file or directory'	mfiandor	OpenFOAM Installation	2	January 25, 2010 09:50
ParaView Compilation	jakaranda	OpenFOAM Installation	3	October 27, 2008 11:46

September 2, 2011, 19:04		#2
huilian08 New Member huilian Join Date: Sep 2011 Posts: 2 Rep Power: 0	here are the command I used to up_load the mesh file from Star-ccm+ to pro-star: rccm,name.ccm,Restart_1 load,name.ccm,Restart_1 I can output fluid velocity data from all mesh cells fine, but somehow even after I save this into star.mdl, but the pro-star does not run the casename star? Instead, it ran a totally different old file. Just more comments on the previous post to clarify the problem. Thanks Huilian