|June 4, 2005, 03:33||
I am dealing with a solidification problem, where indial test case is run with a closed domain without any outlet, considering the flow to be compressible.
I am solving this problem as a multiphase problem .I press the mould through the inlet which is considered incompressible. Already i have air present inside which i consider it as a compressible.
Is it possible to model this case as a hybrid ( both compressible and incompressible)?
As of now, i dont take any temperature effects into consideration. I am trying to analyse the flow nature with pressure distributions.
Or i should take the case of solving it as a compressible flow problem?
Thanks in advance
|Thread||Thread Starter||Forum||Replies||Last Post|
|conduction problem||venkataramana||OpenFOAM||3||December 1, 2013 08:30|
|Problem Importing Geometry ProE to CFX||fatb0y||CFX||3||January 14, 2012 20:42|
|area does not match neighbour by ... % -- possible face ordering problem||St.Pacholak||OpenFOAM||9||November 22, 2011 11:02|
|Problem in modeling solidification||S. Balasubramanyam||CFX||0||January 20, 2004 10:54|
|Is this problem well posed?||Thomas P. Abraham||Main CFD Forum||5||September 8, 1999 14:52|