 |
 |
 |
|
|
|
[Sponsors] | ||||
October 11, 2011, 10:42
|
mass flux residual
|
#1 |
|
New Member
Join Date: Aug 2011
Posts: 1
Rep Power: 0  |
hiii,
im trying to achieve convergence but the mass flux residual dose not reach the desired value (0.001) and my history of residuals is as follows. can i set maximum residual tolerance to 0.1 and assume it reach the required convergence? as even this reach the 100000 iterations, this is exactly how residuals looks like. thanks alot in advance |
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to write k and epsilon before the abnormal end | xiuying | OpenFOAM Running, Solving & CFD | 7 | March 15, 2013 06:08 |
| Orifice Plate with a fully developed flow - Problems with convergence | jonmec | OpenFOAM Running, Solving & CFD | 3 | July 28, 2011 05:24 |
| Extrusion with OpenFoam problem No. Iterations 0 | Lord Kelvin | OpenFOAM | 6 | April 12, 2011 11:24 |
| transsonic nozzle with rhoSimpleFoam | Unseen | OpenFOAM Running, Solving & CFD | 6 | August 27, 2010 07:23 |
| Differences between serial and parallel runs | carsten | OpenFOAM Bugs | 11 | September 12, 2008 11:16 |
Linear Mode
