Problem with forming closed surface set -- CFD Online Discussion Forums

June 17, 2005, 03:39	Problem with forming closed surface set	#1
blip Guest Posts: n/a	Hi, I'm a very new user to CFD-ACE. Recently I have been trying to simulate flow of particles in a pipe. My pipe has 2 segments. The front portion has a smaller diameter and this is in turn joined to a pipe of a larger diameter. After drawing the pipe and trimming the surfaces I have difficulties in forming closed surface set on the front portion of the pipe. The error message I get is always that it doesn't form a closed loop. Anyone able to give me some hints and help on forming closed surface sets? Your help would be greatly appreciated. Thanks.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Problems with coedge curves and surfaces	tommymoose	ANSYS Meshing & Geometry	6	December 1, 2020 11:12
[ICEM] surface mesh merging problem	everest	ANSYS Meshing & Geometry	44	April 14, 2016 06:41
Problem with segment surface and meshing	Silmaril	ANSYS Meshing & Geometry	1	October 13, 2011 16:42
Problem generating a surface mesh	danieldiver	STAR-CCM+	5	August 8, 2011 08:34
Problem installing on 64bit with ver13	jonititan	OpenFOAM Installation	0	April 28, 2006 05:45

All times are GMT -4. The time now is 08:41.