 |
 |
 |
|
|
|
[Sponsors] | ||||
May 9, 2014, 17:34
|
Yplus to high at Boundary Outlet
|
#1 |
|
Member
Daniel Frederik
Join Date: Apr 2014
Location: Switzerland
Posts: 38
Rep Power: 11  |
Hello People
I was analysing a heat exchanger ,two tubes one Inside the other, counterflow. The outer Flow is turbulent Re=300'000. Yplus is ok in general just at the outlet it reaches about 600. I tried to replace the boundary with an opening that didnt help. What do you do in such cases? Would you make the tube longer and that way taking it out of the analyzed length? What else could be done? Thanks in advance .. In the picture only a fourth of the tube is visible, i worked with symmetries... Last edited by Daniel Frederik; May 10, 2014 at 08:55. |
|
|
|
|
|
May 10, 2014, 09:53
|
|
#2 |
|
Member
Daniel Frederik
Join Date: Apr 2014
Location: Switzerland
Posts: 38
Rep Power: 11 |
could somebody change this into the CFX Forum, i didnt want to have it here, my bad..
|
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 06:28 |
| CFX13 Post Periodic interface | EtaEta | CFX | 7 | December 8, 2011 17:15 |
| VOF Outlet boundary condition in cfd - ace | JM | Main CFD Forum | 0 | December 15, 2006 08:07 |
| Solver error message!!! | IoSa | CFX | 1 | September 14, 2006 04:48 |
| Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
Linear Mode
